Chrome Powder

Application When Using Over 3 Step Polish:

1. Prepare and trim the nail/tip as required
2. Lightly buff the surface of the nail to remove the shine. Remove dust and clean the nail plate with GELLUV^®Prep & Wipe solution. Make sure the edges of the nail are properly buffed and cleaned
3. Gently stir GELLUV^®Gel Polish before application
4. Apply GELLUV^®Foundation gel polish onto the nail evenly with a thin application. Cap the free edge. Cure as per Lamp wattage
5. Apply a layer of three-step gel polish onto the nail evenly with a thin application. Cap the free edge. Cure as per lamp wattage
6. Cure under LED or UV Lamp – Curing time as follows* – 36W UV lamp – 60 seconds, 36W LED lamp 30 seconds
7. Do Not Remove sticky layer. Do not touch layers until final coat has been applied, cured and residue removed
8. Apply second layer of three-step gel polish, repeating steps 5 & 6
9. Apply a thin layer of GELLUV^®Gloss & Go – No Wipe Top Coat – DO NOT OMMIT THIS STEP
10. Cure as per step 6
11. Apply Silver or Gold powder with applicator using circular motion until nail surface is covered
12. Remove all excess powder particles using blusher brush or similar – This is important and helps prevent speckled finish
13. Apply 2nd thin coat of GELLUV^®Gloss & Go – No Wipe Top Coat – DO NOT OMMIT THIS STEP
14. Repeat Steps 10, 11 & 12 until the desired finish is achieved (normally 2 coats of powder)